HoneyRamirez HoneyRamirez's blog : What are the types of rotary drilling bits? _ Bedrock
Original title: What are the types of rotary drilling bits? Introduction of
rotary drill bit manufacturer on classification of rotary drill bits: Common
rotary drill bits include auger bits, rotary buckets, barrel core bits,
underreamer bits, percussive bits, percussive grab cone bits and hydraulic grab
buckets 1. Auger bit (1) Conical: double head double screw,fastest
dth hammer, suitable for hard bedrock. Double-headed single screw, suitable
for weathered bedrock, pebbles,DHD
Drill bit, frozen soil with ice, etc. The above drill bits are equipped with
various picks, and many types of drill bits can be derived through the changes
of tooth type, pitch and helix angle. (2) Straight screw bit: a. Bucket tooth
straight screw: double-head double-screw, Tapered
Rock Bit ,mining
dth bit, suitable for sandy soil, small-diameter gravel layer with poor
cementation; double-head single-screw ? Suitable for sandy soil and soil layer;
single head and single screw ? Suitable for large diameter pebbles, cohesive
soil and hard mastic with poor cementation. B. Pick straight screw: double
screw, triple screw and quadruple screw, suitable for hard bedrock or gravel.
The bucket is applicable to a wide range of strata. The single-layer bottom is
only applicable to the soil layer with strong viscosity. The double-door
drilling bucket is applicable to a wide range of strata. The single-door
drilling bucket is only applicable to large-diameter pebbles and hard clay. II.
Rotary drilling bucket can be divided into pick drilling bucket and bucket tooth
drilling bucket according to the teeth installed; and can be divided into
double-layer bottom bucket and single-layer bottom bucket according to the
number of bottom plates. According to the number of doors, it can be divided
into double door buckets and single door buckets. According to the taper of the
barrel, it can be divided into conical barrel drilling bucket and straight
barrel drilling bucket. According to the shape of the low plate, it can be
divided into pot bottom drilling bucket and flat-bottomed drilling bucket. 。 The
above structural forms are combined with each other, and with the change of
whether to have a vent hole and a door opening mechanism, dozens of rotary
drilling buckets can be combined. Generally speaking, double bottom drill III.
Barrel type coring bit At present, there are two common ones: cutter barrel
drill (suitable for medium hard bedrock and gravel) and roller barrel drill with
high drilling efficiency. The difference of coring device mainly depends on the
difficulty of coring. Because the roller core bit is mainly used for hard rock
drilling, and the annular area of drilling is large, if conditions permit,
reverse circulation drilling can be added to the bit part to lift (applicable to
hard bedrock and large boulders). In the two types of drill bits of barrel
coring drill, there are also coring devices and non-coring devices. IV. Reaming
drill bit In order to improve the bearing capacity of single pile on the basis
of no increase of pile diameter and pile depth, the design department often uses
belled pile to realize the hard bedrock of rotary drilling rig. Because the
rotary drilling is a non-circulation drilling,Mining Drilling Equipment, the slag can
be removed with a slag removal bucket after the bottom expansion is completed.
Bottom drill bit is enough. The commonly used reaming bit is mainly mechanical.
This kind of bit is relatively simple to use and maintain. It has an upper
opening type and a lower opening type. The opening mechanism is generally a
four-link mechanism. It can be used for soil, strong wind, moderately weathered
strata and even construction reaming without any change. You only need to select
the reaming back to Sohu to see more. Responsible Editor:. wt-dthtools.com
- Technology